Contact Us

    Hebei Nanfeng Automobile Equipment (Group) Co.,Ltd

    Phone: +86 18811334770

    Tel: +86 0317 8620396

    Tel: +86 010 58673556

    Candy Jiao

    E-mail: nh.jiao@auto-parkingheater.com

    Email: nh.li@auto-parkingheater.com

    Add: Room 505, Building B, Free Town Center, No.58, East Third Ring South Road, Chaoyang District, Beijing, 100022, P.R.China

Battery System Thermal Management 2

Mar 09, 2023

Battery System Thermal Management 2

 

Generally speaking, the cooling modes of power batteries are mainly divided into three categories: air cooling, liquid cooling and direct cooling. The air-cooling mode uses natural wind or cooling air in the passenger compartment to flow through the surface of the battery to achieve heat exchange and cooling. Liquid cooling generally uses an independent coolant pipeline to heat or cool the power battery. At present, this method is the mainstream of cooling. For example, Tesla and Volt both use this cooling method. The direct cooling system eliminates the cooling pipeline of the power battery and directly uses refrigerant to cool the power battery.

 

1. Air cooling system:
In the early power batteries, due to their small capacity and energy density, many power batteries were cooled by air cooling. Air cooling is divided into two categories: natural air cooling and forced air cooling (using fans). The battery is cooled by natural wind or cold air in the cab.

 

2. Liquid cooling system
The liquid cooling mode means that the battery uses cooling liquid to cool the heat. The cooling liquid is divided into two types that can directly contact the cell (silicon oil, castor oil, etc.) and contact the cell (water, ethylene glycol, etc.) through water channels; currently water and Ethylene glycol mixed solutions are more commonly used. The liquid cooling system generally adds a chiller to couple with the refrigeration cycle, and the heat of the battery is taken away through the refrigerant; its core components are the compressor, the chiller and the water pump. As the power source of refrigeration, the compressor determines the heat exchange capacity of the entire system. The chiller acts as an exchange between the refrigerant and the cooling liquid, and the amount of heat exchange directly determines the temperature of the cooling liquid. The water pump determines the flow rate of the coolant in the pipeline. The faster the flow rate, the better the heat transfer performance, and vice versa.

high voltage PTC parking heater application

 

 

Send Inquiry