ESC System
The hardware of the ESC system includes ESC controller, wheel speed sensor, gear ring (integrated on the wheel hub bearing or drive shaft), steering angle sensor, YG sensor, wiring harness and ESP instrument warning light, etc.

1.ESC Controller
The ESC controller assembly consists of ECU electronic control unit, HCU hydraulic control unit, motor and other parts.
With the continuous expansion of ESC system functions, ESC controllers from the same supplier often have multiple different functional versions.

2.Wheel Speed Sensor
The wheel speed sensor collects the rotation speed of the wheel and converts it into an electrical signal by cooperating with the gear ring, and inputs it into the ESC electronic control unit for processing. Commonly used wheel speed sensors are divided into two categories: passive wheel speed sensors and active wheel speed sensors.
Passive wheel speed sensors are also called electromagnetic type. They use the principle of electromagnetic induction to generate a sine wave signal.
Active wheel speed sensors currently mainly use Hall type, which uses the Hall principle to generate a square wave signal.
Because active wheel speed sensors have the advantages of strong anti-interference ability, wide working air gap range and zero-speed output, they have become the mainstream products currently used.

3.YG Sensor
YG sensors are divided into integrated and independent types: the integrated type is to integrate the sensor into the ESC controller, and the independent type is to install the sensor separately near the center of mass of the vehicle. At present, integrated YG sensors have gradually become a trend.
4.Angle Sensor
In previous models, the angle sensor is usually integrated on the steering wheel combination switch as a separate part. However, due to cost considerations, the electric power steering system EPS directly sends the angle signal to the ESC for use, and it has become a trend to cancel the separate angle sensor of the whole vehicle.





