Heat Dissipation Method for New Energy Vehicle Power Lithium Battery


The lithium battery pack module is mainly composed of batteries and freely combined cooling and heat dissipation monomers. The relationship between the two complements each other. The battery is responsible for powering the new energy vehicle, and the cooling unit can handle the heat generated by the battery during operation. Different heat dissipation methods have different heat dissipation media and advantages and disadvantages.
If the temperature around the battery is too high, these materials will use the heat-conducting silicone gasket as the transmission path, smoothly enter the cooling pipe, and then absorb heat through direct or indirect contact with the single battery. The main advantage of this method is that it has a large contact area with the battery cells and can absorb heat evenly. In terms of disadvantages, the liquid cooling medium is not an insulating object, and ethylene glycol and mineral oil are also corrosive. Once leaked, it is easy to corrode the battery and cause a short circuit problem.
The air cooling method is also a common method of cooling the battery. As the name suggests, this method uses air as the cooling medium. Designers of new energy vehicles will install cooling fans next to the battery modules. In order to increase the air flow, vents are also added next to the battery modules. Affected by air convection, the lithium battery of a new energy vehicle can dissipate heat quickly and maintain a stable temperature. The advantage of this method is that it is flexible, and it can dissipate heat by natural convection or by forced heat dissipation. But if the battery capacity is too high, the effect of air cooling heat dissipation method is not good.
The box-type ventilation cooling is a further improvement of the air cooling and heat dissipation method. In addition to controlling the maximum temperature of the battery pack, it can also control the minimum temperature of the battery pack, ensuring the normal operation of the battery to a large extent. However, this method leads to a lack of temperature uniformity in the battery pack, making it prone to uneven heat dissipation. The box-type ventilation cooling strengthens the wind speed of the air inlet, coordinates the maximum temperature of the battery pack, and controls the huge temperature difference. However, due to the small gap of the upper battery at the air inlet, the gas flow obtained does not meet the heat dissipation requirements, and the overall flow rate is too slow. If things go on like this, the heat accumulated on the upper part of the battery at the air inlet is difficult to dissipate. Even if the top is slit in the later stage, the temperature difference between the battery packs still exceeds the preset range.
The phase change material cooling method has the highest technological content, because the phase change material can absorb a large amount of heat according to the temperature change of the battery. The great advantage of this method is that it consumes less energy and can reasonably control the temperature of the battery. Compared with the liquid cooling method, the phase change material is not corrosive, which reduces the pollution of the medium to the battery. However, not all new energy trams can use phase change materials as cooling medium, after all, the manufacturing cost of such materials is high.
As far as the application is concerned, fin convection cooling can control the maximum temperature and maximum temperature difference of the battery pack within the range of 45°C and 5°C. However, if the wind speed around the battery pack reaches a preset value, the cooling effect of the fins through the wind speed is not strong, so that the temperature difference of the battery pack changes little.
Heat pipe cooling is a newly developed heat dissipation method, which has not yet been officially put into use. This method is to install the working medium in the heat pipe, once the temperature of the battery rises, it can take away the heat through the medium in the pipe.
It can be seen that most heat dissipation methods have certain limitations. If researchers want to do a good job in the heat dissipation of lithium batteries, they must set up heat dissipation devices in a targeted manner according to the actual situation, so as to maximize the heat dissipation effect. , to ensure that the lithium battery can work normally.






