Research on Thermal Management of Immersed Batteries

Batteries' performance, life, and safety are closely related to temperature. High temperature and uneven temperature distribution will greatly reduce the battery cycle life and charging and discharging efficiency. If the temperature continues to rise and reaches the critical temperature of battery thermal runaway, it will cause the battery to catch fire or even explode. On the other hand, the internal resistance, heat generation, and energy consumption of lithium-ion batteries will increase in low temperature environments. Therefore, it is very important to control the battery to work within the optimal temperature range, reduce the maximum temperature difference between batteries, and ensure the temperature uniformity between single cells.
In recent years, with the continuous improvement of battery thermal management system requirements, liquid cooling systems are increasingly used in battery thermal management. They mainly use cold plates, water jackets, heat sink fins and other liquids to manage battery temperature in a non-direct contact manner, but the non-direct contact method reduces the liquid heat dissipation/heating efficiency.
Thermal management system structure and principle
The liquid direct contact battery thermal management system studied in this paper includes battery packs, battery boxes, radiators, electronically controlled two-position three-way valves, oil pumps, filters and through-type PTC heaters.
In the liquid direct contact battery thermal management system, the battery box is filled with liquid, and the battery pack is completely immersed in the liquid, which requires the liquid to have good insulation. Silicone oil has the advantages of large specific heat capacity, good thermal conductivity, medium and low viscosity coefficient, high ignition point, good insulation, and good low-temperature fluidity. After comprehensive analysis, silicone oil is selected as the circulating medium of the thermal management system, with a density of 960 kg/m3, a specific heat capacity of 1510 J/(kg·K), a thermal conductivity of 0.157W/(m·K), a kinematic viscosity of 0.003 84 m2 /s, and a pour point of -60'C.
During heat dissipation, the controller controls the two-position three-way valve to connect the radiator to the circuit, close the heating circuit, and realize the heat dissipation function of the system; during heating, the controller controls the two-position three-way valve to connect the PTC heater to the circuit, close the heat dissipation circuit, and realize the heating function of the system.






