Home > Products > Electric Vehicle Parts > High Voltage Coolant Heater > 1-10KW High Voltage Coolant Heater

Products

8KW PTC High Voltage Coolant Heater

Name: 8KW PTC High Voltage Coolant Heater Suppliers and Manufacturers China - Factory Quotation - NANFENG
Brand: Nanfeng
SKU: 191258285

PTC Water Heater can provide heat for the cockpit of new energy vehicles and meet the standard of safe defrosting and defogging. At the same time, it provides heat to other parts of the vehicle that require temperature regulation.

Send Inquiry

Description

If you're looking for the 8kw ptc high voltage coolant heater, welcome to wholesale the product from our factory. As one of the leading manufacturers and suppliers in China, we will offer you the best service and fast delivery. Now, check the quotation with our seller.

8KW PTC High Voltage Coolant Heater

Product Description

Features

• use electric heating antifreeze to heat the interior of the vehicle through the heater core.

• Installed in a water-cooled circulating system.

• The heater is gentle and temperature-controlled The power of IGBT is regulated by PWM.

• It has a short-term heat storage function.

• Cycle the vehicle to support battery heat management.

• Environmental Protection.

Product Parameters

Item	WPTC-13
Rated voltage(VAC)	430VAC (323-552VAC/50Hz&60Hz, three-phase four-wire power supply), inrush current I≤30A;
Ambient temperature:	-40~105℃
Ambient humidity:	5%~90%RH
Medium:	50% water/50% ethylene glycol
Heater protection grade:	IP67
Heater weight:	3.7±0.1Kg
Heater air tightness:	apply pressure 0.6MPa, test for 3min, the leakage is less than 500Pa

coolant heater details (2).jpg

Installation Advice

coolant heater installation.jpg

To ensure maximum energy efficiency of the plumbing PTC, the following points should be noted during installation:

The PTC shall be at its highest point below the expansion tank.
Pump no higher than PTC.
PTC should be installed after the pump and before the heater core.
Pay attention to the direction of PTC entering and leaving the water.
PTC before the first work, or after the maintenance of pipeline components should make the pump first operation, and confirm that the exhaust, and then to PTC power.