Car Water Pump
The water pump is an important part of the car engine system. In the cylinder block of the car engine, there are multiple water channels for cooling water circulation. They are connected to the radiator (commonly known as the water tank) placed at the front of the car through water pipes, forming a large The water circulation system has a water pump installed at the upper water outlet of the engine. It is driven by the fan belt to pump out the hot water in the water channel of the engine block and pump in the cold water.
There is a thermostat next to the water pump. When the car is just started (cold), it is not opened so that the cooling water does not pass through the water tank and only circulates in the engine (commonly known as small circulation) until the engine temperature reaches above 95 degrees. When the car is running, it is opened, and the hot water in the engine is pumped into the water tank. When the car moves forward, the cold wind blows through the water tank and takes away the heat.



How does a water pump work?
Centrifugal water pumps are widely used in automobile engines. Their basic structure consists of water pump housing, connecting plate or pulley, water pump shaft and bearings or shaft-connected bearings, water pump impeller and water seal device. The engine drives the water pump bearing and impeller to rotate through the pulley. The coolant in the water pump is driven by the impeller to rotate together. Under the action of centrifugal force, it is thrown toward the edge of the water pump casing. At the same time, a certain pressure is generated, and then flows out from the water outlet or water pipe. The pressure at the center of the impeller is reduced because the coolant is thrown out. The coolant in the water tank is sucked into the impeller through the water pipe under the pressure difference between the water pump inlet and the center of the impeller, realizing a reciprocating circulation of the coolant.
How to maintain water pumps
1. First use the sound to determine whether the bearing is in good condition. If the sound is abnormal, the bearings need to be replaced.
2. Disassemble the impeller and check whether it is worn. If it is worn, it will affect the flow and lift efficiency and needs to be replaced.
3. Check whether the mechanical seal can continue to be used. If it cannot be used, it needs to be replaced.
4. Check whether the oil tank is short of oil. If so, add oil to the appropriate location.
Of course, it is difficult for ordinary car owners to complete the above steps, and it is difficult to maintain and repair the water pump by themselves. At the same time, as a mid-term maintenance item, the water pump has a long replacement cycle and is often ignored by car owners. Therefore, for most car owners, regular inspection and replacement when necessary are the best ways to maintain the water pump.






