● First installation
- The first installation of the fuel stove, in order to completely remove the air in the fuel supply system, so that the fuel pipeline filled with fuel, special special pump fuel function.You can use the function of quick fuel pump by holding down the ventilation key and not letting go.
First, press the air conditioner lamp when it is lit, and then press the warm air button. The warm air lamp is also lit.If any key is pressed during the fast fuel pumping, the fast fuel pumping stops.
-- The fuel stoves should be tested before use.Carefully check all connections for leaks and safety during the trial run.In case of smoke emission, abnormal combustion noise or fuel odor, turn off the heater and unplug the fuse so that it cannot operate.After professional maintenance can be used. The first time you use a fuel stove, it may take a short time Smell.This is normal in the first few minutes of operation, and it does not mean that the fuel stoves are not functioning properly. maintenance
- During maintenance, an inspection must be conducted by a professional to carry out the following maintenance work: Check inlet and outlet for contamination and foreign matter. Clean the outside of the fuel stove. Check the circuit connector for rust and looseness. Check the intake and exhaust pipes for obstruction or damage. Check the fuel line for leaks.
● Long-term shutdown -- When the fuel stove is not in use for a long time, it should be operated once every 4 weeks for about 10 minutes each time to prevent failure of mechanical parts such as combustion air fan (fixed). - When replacing low-temperature fuel, make the fuel stove run for at least 15 minutes and fill the fuel system with new fuel.
● Fuel oven life
-- The heat exchanger for the fuel range shall not be used for more than 10 years.After expiration, it must be replaced by genuine parts and replaced by the fuel stove manufacturer or its authorized agent. The exhaust pipes from the fuel stoves that discharge combustion gases must be replaced with genuine parts when they have been in use for 10 years.
● Other precautions
-- In the process of transportation and storage, the ambient temperature should not exceed -40℃ ~ 85℃ to prevent damage to electronic components.
- Only authorized customer service stations are allowed to install and repair the heater, and the use of non-original parts is prohibited to avoid risks. The manufacturer is not responsible for the warranty of heater damage caused by improper installation and operation. You must turn off the fuel range before refueling.
- When welding the car, first remove the positive power line of the fuel stove from the battery and ground it to prevent damage to the controller
