Heater Working Steps
When the switch is activated, the heater works as follows:
1. The centrifugal water pump starts pumping test run to check whether the waterway is normal;
2. After the water circuit is normal, the fan motor rotates to blow air in through the intake pipe, and the dosage oil pump pumps oil into the combustion chamber through the input pipe;
3. The ignition plug ignites;
4. After the fire is ignited at the head of the combustion chamber, it burns completely at the tail, and the exhaust gas is discharged through the exhaust pipe:
5. The flame sensor can sense whether the ignition is on according to the temperature of the exhaust gas, and if it is on, the spark plug will be turned off;
6. The heat is absorbed and taken away by the water through the heat exchanger, and circulated to the engine water tank:
7. The water temperature sensor senses the temperature of the water outlet. If it reaches the set temperature, it will shut down or reduce the combustion level:
8. The air controller can control the intake volume of combustion air to ensure the efficiency of combustion;
9. The fan motor can control the speed of the incoming air;
10. The overheat protection sensor can detect that when there is no water or the waterway is blocked and the temperature is higher than 108 degrees, the heater will be automatically turned off.
Because the heating effect of the parking heating system is good, it is safe and convenient to use, and it can also realize remote control operation. It can preheat the car in advance in the cold winter, which greatly improves the comfort of the car. Therefore, it has been used in some high-end models. Standard configuration, such as imported Audi Q7, BMW X5, new 7 series, Land Rover Range Rover, Touareg TDI diesel version, imported Audi A4 and R36, etc. In some alpine regions, many people install it at their own expense, especially for trucks and RVs used in the north, which are basically installed.






