Installation points:
1.Fixing of oil pot and oil pump:
The position of the oiler should be fixed to facilitate subsequent fuel filling and at the same time not to affect the lift of the front of the car. Suggestion for the installation of the oil pump: the oil outlet should be higher than the oil inlet, and the angle should be 45°-60°.
2. Fixing of intake pipe, exhaust pipe and oil pipe:
The difference between the outlet of the intake pipe and the exhaust pipe should be more than 15cm to prevent the exhaust gas from being sucked into the machine again. The temperature of the exhaust pipe will reach about 200° when the heater is working, so when fixing the exhaust pipe, avoid the line and the oil circuit. If conditions permit, you can blow the engine.
3.the host fixed:
The main points for fixing the host are as follows:
First: the main engine must be stable. There are two main installation methods for the main engine. The most used one is the installation method in the schematic diagram, the exhaust pipe is installed vertically, and the other installation method is the exhaust pipe and the car wall. Vertical installation method, but this method has higher installation requirements, and the glow plug must be required to face upwards, otherwise there will be fuel overflow, and there will be a great safety hazard.
Second: The air inlet of the main unit must leave an air intake distance of more than 5cm, and the air outlet must be kept unobstructed. Of course, nothing can be placed on the heater to prevent the heater from being shut down at high temperature during the working process or even the thermosetting plastic shell. Baking deformation.
Third: The installation of the parking heater should take into account the maintenance situation, so try to leave more than 5cm of space on the left and right of the body to ensure easy maintenance. Car plumbing heaters share the installation points of parking heaters and hope to help you.








