Contact Us

    Hebei Nanfeng Automobile Equipment (Group) Co.,Ltd

    Phone: +86 18811334770

    Tel: +86 0317 8620396

    Tel: +86 010 58673556

    Candy Jiao

    E-mail: nh.jiao@auto-parkingheater.com

    Email: nh.li@auto-parkingheater.com

    Add: Room 505, Building B, Free Town Center, No.58, East Third Ring South Road, Chaoyang District, Beijing, 100022, P.R.China

Lithium-ion battery thermal management technology

Aug 04, 2023

Lithium-ion Battery Thermal Management Technology

 

As the mainstream battery in the global power battery and consumer battery field, lithium-ion battery has attracted much attention in the development of its thermal management technology. The early lithium-ion battery thermal management system was relatively simple, mainly through natural convection cooling, that is, passive air cooling. Later, fans were added to speed up the air flow or the cold air tank was used to cool the air in advance, that is, active air cooling. The cooling effect was improved, but the noise was loud and the temperature uniformity was not good. To solve this problem, researchers have invented liquid cooling technology, including cooling plate liquid cooling and immersion liquid cooling. Among them, the cooling plate liquid cooling technology is relatively mature and has a good cooling effect, but it is prone to problems such as coolant leakage, which may cause safety hazards. Immersion liquid cooling is a cooling technology that has developed rapidly in recent years. The cooling effect is obvious, but it has high requirements for cooling liquid. Phase-change material (PCM) cooling and thermoelectric cooler (TEC) cooling technology are new cooling technologies developed in recent years, which have no moving parts and simple structure, but low cooling efficiency. Overall, the cooling technologies at this stage have advantages and disadvantages. In general, it is necessary to combine two or more cooling technologies to perform compound cooling on the battery.

electric bus ptc heater application

Electric Heater PTC Heater application

PTC Air Heater

Air cooling is generally divided into two types: natural cooling and forced cooling. Air flow is used to take away the heat generated by the battery and then cool the battery. It has the advantages of simple structure, low cost, and no pollution.

 

Natural cooling is a passive cooling method that often only requires the design of cooling air ducts. It was widely used in early lithium-ion electric vehicles. However, natural air cooling is difficult to meet the cooling needs of its power batteries. Therefore, in order to ensure the long cycle life of high-end fast-charging electric vehicles, it is necessary to configure a more efficient thermal management system. Forced air cooling is an active air cooling technology that enhances heat transfer by using external energy to promote air flow. Currently, in the field of electric flight equipment, air cooling is still the primary cooling technology of choice. Compared with liquid cooling technology, air cooling technology is lighter in weight, does not increase the weight burden of flight equipment, and has lower energy consumption.

HVH heater

high voltage coolant heater1

PTC Coolant Heater

Liquid cooling is a cooling technology that uses liquid as the cooling medium and uses the phase change or flow of the cooling liquid to exchange heat with the heat-generating components of the battery system. It has the advantages of fast heat dissipation and high cooling efficiency. Generally, it is divided into direct liquid cooling and indirect liquid cooling. The direct liquid cooling coolant is in direct contact with the heating device, such as the representative immersion liquid cooling. The cooling liquid of indirect liquid cooling does not directly contact the heat-generating device, but flows in specific components to indirectly cool the battery, such as cooling plate liquid cooling.

Send Inquiry