Contact Us

    Hebei Nanfeng Automobile Equipment (Group) Co.,Ltd

    Phone: +86 18811334770

    Tel: +86 0317 8620396

    Tel: +86 010 58673556

    Candy Jiao

    E-mail: nh.jiao@auto-parkingheater.com

    Email: nh.li@auto-parkingheater.com

    Add: Room 505, Building B, Free Town Center, No.58, East Third Ring South Road, Chaoyang District, Beijing, 100022, P.R.China

Fuel Cell Vehicle Thermal Management

Aug 15, 2023

Fuel Cell Vehicle Thermal Management

 

Although fuel cells are still mainly used in commercial vehicles, only Toyota, Honda and Hyundai have products for passenger cars, but because the article focuses on passenger cars, and other compared models are also passenger cars, so here is Toyota Take Mirai as an example. The thermal management system of the fuel cell is characterized by the following three points:

 

Cooling requirements for fuel cell stacks
The stack is the place where hydrogen and oxygen react, and generates heat energy while generating electricity. The increase in temperature is helpful to increase the discharge power of the stack, but it cannot accumulate heat. Therefore, the reaction product water and the stack cooling liquid need to flow together to exchange heat to remove heat. Moreover, maintaining the stack temperature can effectively control the output power and meet the driver's dynamic demand for the drive system. The heat generated by power electronics such as stacks and motor inverters can be used as part of the heat for cabin heating in winter.

electric bus ptc heater application

Electric Heater PTC Heater application

5kw high voltage coolant heater application

hvc high voltage coolant heater application

Stack cold start problem
The fuel cell stack cannot directly provide electrical energy at low temperatures, and the stack needs to be preheated by external heat before it can enter the normal working mode. At this time, the heat dissipation circuit just mentioned needs to be turned into a heating circuit in reverse, and the switching here may require the use of a circuit control valve similar to a three-way two-way valve. Heating can be done by an external electric heater whose heating power is supplied from a battery. It seems that there is also a technology that can make the stack self-heating, so that more energy generated by the reaction can heat up the stack body in the form of heat energy.

5kw PTC coolant heater

high voltage coolant heater

24kw high voltage coolant heater1

high voltage coolant heater

Boost cooling
This part is a bit like the hybrid car just mentioned. In order to meet the power demand of the stack, the amount of reactant oxygen also has a certain demand, so the air intake needs to be pressurized to increase the density, thereby increasing the oxygen mass flow rate. For this reason, the cooling after supercharging is brought. Since the temperature range is relatively close to that of other components, it can be connected in series in the same cooling circuit.

Send Inquiry