Car air conditioning system heating methods
As a convenient means of transportation, the ride comfort of a car is also one of the key factors. Pure electric vehicles cancel the engine and there is no engine waste heat. This is a big challenge for the design of heating for drivers and passengers. It also brings development opportunities for the design of other heating methods. Currently, the heating methods used include fuel (gas) heating, heat pump heating and PTC heating to solve the heating problem of pure electric vehicle drivers and passengers.
Fuel heating method
The principle of the fuel heating method is to take measures to burn the fuel in the heater to generate heat, and to heat the air or water around the heater to increase the temperature inside the cabin. The heated air can be either circulating air in the cabin or fresh air outside the cabin. The air-type fuel heater is mainly composed of four parts: motor fan part, ventilation and heat exchange part, atomization combustion part, and combustion exhaust gas removal pipe.

Air Parking Heater

Air Parking Heater
Its working principle is that when the heating switch is turned on, the solenoid valve is energized and opened. At the same time, the motor drives the oil pump to work, and the large fan and small fan rotate together. The oil pump sends the fuel to the atomizer. After it is mixed with the air sucked by the small fan and atomized (the gas does not need to be atomized and directly supplied to the combustion chamber), it is ignited by the electric heating wire of the glow plug. After the mixed gas is burned, the glow plug stops working and the fuel It continues to burn in the combustion chamber, and the heat is transferred to the cold air sucked in by the large fan through the heat exchange device, so that its temperature rises and turns into hot air, which is then sent from the outlet to the driver's cabin or other areas that need to be heated, such as the front windshield, etc. Where defrosting is required, the exhaust gas produced by combustion is discharged from the vehicle through the exhaust pipe.
The water parking fuel heater is mainly composed of four parts: the motor pumping part, the water-passing heat exchange chamber, the atomization combustion chamber, and the combustion exhaust gas removal pipe. Its working principle is similar to that of the air-type heater. This kind of independent fuel or gas heating system for automobiles is characterized by high thermal efficiency, large heat capacity, and rapid heating. It is generally used in alpine areas. The disadvantage is that it does not completely solve the problem of passenger vehicles burning fossil fuels and emitting pollution.

Water Parking Heater

Water Parking Heater
Heat pump heating method
Heat pump heating is based on the electric compressor refrigeration circuit and adds a solenoid valve to control the flow of refrigerant. It absorbs heat from the surrounding environment by evaporating the refrigerant in the condenser, and then condenses and releases the heat through the indoor evaporator to increase the indoor temperature. , meet the regulatory requirements for defrosting and defogging and provide a comfortable temperature environment for drivers and passengers.

PTC heating method
At present, most electric vehicles use PTC heaters, which can realize automatic temperature control and automatic protection for lack of wind (at the highest temperature), and are highly safe.

PTC Coolant Heater

PTC Coolant Heater






