Liquid parking heater manual
1.Application range/specification
Purpose of water parking heater
The structure of the water parking heater is designed for installation on M1 class models. It is not allowed to install on O, N2, N3 class vehicles and dangerous goods transport vehicles. The corresponding regulations must be observed when installing on special vehicles. Approved by the company, it can be applied to other vehicles.
After the water parking heaters_connected to the heating system of the car, it can be used for:
—Heating in the car;
—Defrost the car window glass;
—Preheated water-cooled engine (when technically possible).
This kind of water heating heater does not depend on the vehicle engine when working, and is integrated in the vehicle's cooling system, fuel system and electrical system.
2.Specifications
Hydronic Evo V5-D
A water parking heater using "diesel" fuel.
Hydronic Evo V5-B
A water parking heater using "gasoline" fuel.
The water parking heater uses 12 volts. For technical parameters, see, "Technical Parameters".
3.Installation place/lnstallation location
The parts near the vehicle body and the heater must be protected from excessive heat radiation and contamination from fuel or oil.
Combustion heaters are not allowed to present a fire hazard even when they are overheated. If you pay attention to maintaining sufficient distance from all parts during installation, take proper ventilation measures, and use fireproof materials or heat insulation boards, then this requirement can be met.
The heater is best installed in the engine compartment, between the wheel cover and the front bumper.
The installation position should be as low as possible to ensure that the heater and the circulating pump can exhaust by themselves. This article is especially suitable for circulating pumps that can't inhale spontaneously.
