Contact Us

    Hebei Nanfeng Automobile Equipment (Group) Co.,Ltd

    Phone: +86 18811334770

    Tel: +86 0317 8620396

    Tel: +86 010 58673556

    Candy Jiao

    E-mail: nh.jiao@auto-parkingheater.com

    Email: nh.li@auto-parkingheater.com

    Add: Room 505, Building B, Free Town Center, No.58, East Third Ring South Road, Chaoyang District, Beijing, 100022, P.R.China

Technical Specification For PTC Electric Heater

Oct 25, 2022

Technical Specification for PTC Electric Heater


1 Scope of application 

This PTC electric heater is suitable for electric / hybrid / fuel cell vehicles and is mainly used as the main heat source for temperature regulation in the vehicle. The PTC electric heater is applicable to both vehicle driving mode and parking mode. In the heating process, electric energy is effectively converted into heat energy by PTC components. Therefore, this product has faster heating effect than internal combustion engine. At the same time, it can also be used for battery temperature regulation (heating to working temperature) and fuel cell starting load. 


The PTC electric heater adopts PTC technology to meet the safety requirements of passenger cars for high voltage. In addition, it can also meet the relevant environmental requirements of components in the engine compartment. 


The purpose of PTC electric heater in application is to replace the engine block as the main source of heat source. By supplying power to the PTC heating group, the PTC heating component is heated, and the medium in the circulating pipeline of the heating system is heated through heat exchange. 


The main performance features are as follows: 

With compact structure and high power density, it can flexibly adapt to the installation space of the whole vehicle. 

The use of plastic shell can realize the thermal isolation between the shell and the frame, so as to reduce the heat dissipation and improve the efficiency. 

Redundant sealing design can improve the reliability of the system. 


2 Design principle

The PTC electric heater module consists of PTC heating components, controllers and internal pipelines. The heating component is installed in the aluminum die casting, the aluminum die casting and the plastic casing form a closed circulation pipeline, and the cooling liquid flows through the heating body in a meander structure. 


The electrical control part is an aluminum die-cast body covered with a metal casing. The controller circuit board is secured with screws and the connector is directly attached to the circuit board. The electrical principle block diagram is shown in Figure 1 below:

PTC heater

               Figure1  Electric principle block diagram


The high-voltage part is inside the red frame, and the low-voltage part is outside the red frame. The high-voltage control unit and the low-voltage control unit contain circuit components such as microprocessors. 



The control unit realizes the current and voltage sampling of the high-voltage loop through the shunt and sampling resistance respectively, so as to realize the protection of abnormal work. The temperature sensor NTC_C is used to detect the temperature of the PCB and protect it in time when the temperature is too high. 


There is TVS at the power supply inlet of the low-voltage part to effectively prevent surges. A high-frequency isolation transformer is used to provide auxiliary power for the high-voltage side. Communication information is exchanged between the high- and low-voltage control units through digital isolators. With hard-wired wake-up function, it can realize wake-up and sleep function. Input auxiliary power supply part current limiting protection function. The temperature sensors NCT_A and NTC_B located at the water inlet and water outlet respectively are used to detect the temperature of the coolant in real time and protect it in time when the temperature is too high.


Send Inquiry